The process is repeated at the other end...the skin on this end overlaps the skin that was put on first.
posted by Chip at 9:01 PM
Tuesday, April 26, 2005
The process is repeated at the other end...the skin on this end overlaps the skin that was put on first.
Previous Posts
- Proper use of the aerocrafters tool belt saves a l...
- Get it straight along the trailing edges and at th...
- It should read the same angle all along the h.s. ...
- Eliminating twist in the h.s. is very important an...
- These snazy orange tie downs are great for getting...
- The right skin goes on...keeping this assembly str...
- This is where we left off...but now the missing ri...
- Back to the horizontal stabilizer. As you will re...
- Here are two of the hinges being prepared for moun...
- Before mounting the hinges, the holes in the eleva...
<< Home